Hi again (sorry, i hope i not too intrusive), but i wrote this to tech support and no get answer yet.
So, try to reproduce it please:
1) Load Shift (stereo or mono version), make any input signal, and click to preset #2 for example - sound changed properly.
2) Then click again to preset #1
3) Then just open "Bands" list and select the same default value again (512) that already selected - sound will changed again, very noticeable by ear.
The same behavior in Warp: load for example preset #5, then again #1, and then re-select current Bands 1024 to the same 1024, the sound will change immediately.
I.e. there is a feeling that the sound does not return to its initial state #1 automatically, it occurs only after re-selection Bands.
In addition, this Bands parameter in Shift - can't changed during morfing between presets. (In Warp changed properly.)
Solved (i got answer via email)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)