Printable Version of Topic

Click here to view this topic in its original format

Plugivery Forums _ Nomad Factory _ Original Cosmos To Cosmos 3

Posted by: teksonik_2 Apr 23 2024, 01:38 PM

As a Cosmos license owner will I receive Cosmo 3 for free? I believe you've been saying updates will be free. smile.gif

EDIT: Nevermind I found the installer in the new Magnetics bundle. I was looking for a separate installer.

Thanks for the free update. Very nice !


Posted by: teksonik_2 Apr 23 2024, 03:53 PM

Is it my imagination or is the Limiter not working in Cosmos 3? Anyone else find the same?

Posted by: hayright Apr 23 2024, 08:48 PM

I'm using the VST2 version and the limiter is working here - it's a brickwall with little bit of lookahead, I think. You can't set threshold but you can drive into it and back down the output.

I think Cosmos 3 is quite a different plugin than the original Cosmos, there's a lot more going on it seems. I surmised the original Cosmos was EQ curves going into an aggressive limiter (super fast too, so it chopped off peaks instead), while this new one introduces frequency dependant saturation curves too, in addition to a very clean limiting behavior, so it's less noticable compared to the original.

Magnetic 3 and Echoes 3 are also very good so far. A lot more familiar but they seem improved.

Posted by: teksonik_2 Apr 23 2024, 09:50 PM

QUOTE (hayright @ Apr 23 2024, 09:48 PM) *
I'm using the VST2 version and the limiter is working here - it's a brickwall with little bit of lookahead, I think. You can't set threshold but you can drive into it and back down the output.


Ok it's working now. I need to try and replicate the result I got earlier because it was definitely not brickwalling. Not a big deal as I can just put another limiter behind Cosmos. I mostly use the exciters and stereo effects.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)