Have a problem with authorization not remembered...Windows 7 32bit.
Installed, entered my serial, authorization successful, asks for a relaunch.
When I relaunch it asks for authorization again

Hello axembler,

I have sent mail to Ircam.

We will try to figure out what is causing this and get back to you.


Best Regards,

Nick

Same issue here.. I'm on Windows 8.1 64 Bit and the license was purchased back when TS was only available for Mac.
Hoping for a solution within the next 15 days!

Regards,
Michael

Hi Michael,

Thanks for your interest in DontCrack and Ircam TS.

We have had reports that there is a problem with the authorisation on Windows.

Ircam is working hard on correcting the new Windows version and we should have a fix this week.

Meanwhile you can just use the 'demo' mode that should give you 15 days of not having to reauthorise every time as you have noted.

I expect to hear about the new version very soon.

Best Regards,

Nick

Hi André,

We have had reports that there is a problem with the authorisation on Windows.

Ircam has worked hard on correcting the new Windows version and we have just posted the new 1.0.9 on the Plugivery site .

Try it, it should correct this problem, if you have any problems please get right back to me.

Best Regards,

Nick